An especially handy (and inexpensive) dispenser
Google Drive project files:
https://drive.google.com/open?id=1_sR2fBU4ZWO-KdJ2...
Instructions to create your own:
You will need:
Bottle of Purell to take pump from (https://www.jeancoutu.com/en/shopping/product/hand...)
Container (recommend Snaplock 500mL https://www.canadiantire.ca/en/pdp/snaplock-rectan...)
Heat shrink tubing (ideally 3/8 Inch - 3/16 Inch https://www.homedepot.ca/en/home/p.heat-shrink-tub...)
1/4 in clear cinyl tubing (https://www.homedepot.ca/en/home/p.clear-vinyl-tub...)
Handisan Button Casing (see .stl file)
Optional if desk mounted:
Clamp (recommend F-clamp https://www.canadiantire.ca/en/pdp/mastercraft-f-c...)
Rubber bands to prevent slipping
Assembly:
Print button casing
Burn or cut correct sized hole in top lid of container for pump
Press pump in place and trim lower tube on angle so that it reaches bottom of container
Cut vinyl to correct length and fit to pump using heat shrink wrap
Feed tube through the printed casing and snap top of pump to bottom of casing*
*Note, you will need to trim a small piece off the side of the pump (e.g. using side cutters) to achieve a perfect fit
Voila!
| PROJECT FILES | Download |